Chapter 6: IP interface configuration
50 Installing and Configuring the Avaya S8400 Media Server February 2006
Programming the SIPI for static addressing
You administer the static IP address for the circuit pack directly through the Ethernet port
connection on the faceplate. For more information, see Figure 3
.
Figure 3: Connecting the laptop directly to the SIPI
Note:
Note: Ensure that you have the password before proceeding.
Depending on the operating system on the Services laptop computer, you might need to clear
the Address Resolution Protocol (ARP) cache before entering a new IP address. If you enter an
IP address and your computer cannot connect, try clearing the cache.
1. On your laptop computer, click Start > Run to open the Run dialog box.
2. Type command and press Enter to open a MS-DOS Command Line window.
Figure notes:
1. Services laptop
2. PCMCIA Network Interface Card (NIC)
3. NIC adapter cable (if necessary)
4. CAT5 crossover cable to SIPI
cadlipsi KLC 031502
1
2
CLK
S
E
R
V
I
C
E
N
E
T
W
O
R
K
3
4
To Next Page
Loading...
