Avaya S8400 - Testing the SIPI Circuit Pack; Testing the License File

Chapter 8: Installation verification
64 Installing and Configuring the Avaya S8400 Media Server February 2006
Testing the SIPI circuit pack
These steps test all the clock and packet interface components within the TN8412AP SIPI
circuit pack.
1. In a SAT command line, enter test ipserver-interface <UUC>, where <UUC> is the
cabinet and carrier in which the circuit pack is located.
2. Verify that the Test Results screen shows PASS in the results column.
Testing the license file
!
Important:
Important: Wait at least 30 minutes after you install the Communication Manager license
before you run the test.
1. On a SAT command line, type test license and press Enter.
2. Verify that the Test Results screen shows PASS in the results column.
For more detailed information on LEDs, see Maintenance Procedures for Avaya
Communication Manager, Media Gateways and Servers, 03-300432.