Avaya S8700 - Pre-Installation Setup

Job Aid
14
July 2003
555-245-768, Issue 1
Comcode 700281124
Install New Hard Drive
1. Insert the new hard drive into the hard drive bracket so that the end of the hard drive is 1/8 to 1/4 inches from
the faceplate of the bracket (‘‘Hard Drive Bracket and Hard Drive’’ on page 13).
2. Reinsert the four bracket screws to attach the hard drive to the bracket (‘‘Hard Drive Bracket and Hard Drive’’
on page 13).
3. Reattach the ribbon cable. Be sure the red stripe on the cable is on the side closest to the power cable.
4. Reattach the power cable (‘‘Hard Drive Bracket and Hard Drive’’ on page 13).
5. Lay the ribbon cable into the media server housing as it was before disconnecting it. This prevents bunching
of the cable when you slide the hard drive bracket back into the media server.
6. Slide the hard drive bracket into the media server, and hand-tighten the screws on the faceplate to secure it to
the media server. Do not tighten the screws with a screwdriver.
!
CAUTION:
Be sure the ribbon cable is pushed completely inside the media server and is not bunched, pinched, or
caught between the top of the hard drive and the hard drive slot.
Replace the Cover of the S8700 Media Server
1. Replace the cover onto the media server (‘‘Media Server Cover Removal and Replacement’’ on page 12). Be
sure the inner rail guides of the cover set correctly on the bottom rails of the media server.
2. Slide the media server cover forward so the covers’ tabs slide into place under the top slots of the front panel.
3. Screw the two cross-point (Phillips) screws into the back of the media server to hold the cover in place
(‘‘Media Server Cover Removal and Replacement’’ on page 12).
4. Reattach the brackets to the sides of the cover with the hex-head bracket screws.
5. Return to ‘‘Tasks for Replacing a Hard Drive on an S8700 Media Server’’ on page 5 to continue with the listed
tasks.