Job Aid
July 2003
5
555-245-768, Issue 1
Comcode 700281124
Tasks to Replace the Hard Drive
Checklist 3. Tasks for Replacing a Hard Drive on an S8700 Media Server
9 Task Description
1 Unplug the Media Server with
the Failed Hard Drive
Unplug the media server from its power source.
Caution: Turning off power in this way can corrupt data on the hard drive.
Use this method to power down the media server only when you are ready
to replace the failed hard drive.
2 Disconnect All the Cables Disconnect all the cables from the back of the media server with the failed
hard drive.
Note: Be sure to label the cables for easy reconnection. See Getting
Started with the Avaya S8700 Media Server with the G600 Media Gate-
way, 555-234-240, Getting Started with the Avaya S8700 Media Server
with MCC1 or SCC1 Media Gateway, 555-234-241, or Server and CSS
Separation—Avaya S8700 Media Server Job Aid.
3 Remove Media Server from
Rack
Remove the media server from the rack. See Getting Started with the
Avaya S8700 Media Server with the G600 Media Gateway, 555-234-240,
or Getting Started with the Avaya S8700 Media Server with MCC1 or SCC!
Media Gateway, 555-234-241.
4 Remove the Cover of the
S8700 Media Server
See ‘‘Remove the Cover of the S8700 Media Server’’ on page 11.
5 Replace the Hard Drive See ‘‘Replace the Hard-drive’’ on page 11.
6 Replace the Cover of the
S8700 Media Server
See ‘‘Replace the Cover of the S8700 Media Server’’ on page 14.
7 Reinstall the Media Server in
the Rack
Reinstall the media server in the rack. Leave all the cables unconnected.
8 Power up the Media Server with
the Replaced Hard Drive.
Plug the media server into the appropriate UPS to power it up. If it does
not power up, press the power button and release it quickly.
Note: Wait at least 3 minutes for the media server to complete its power
up. Watch the LEDs on the media server to see when they stop flashing
and stay solidly lit.
To Next Page
Loading...
