EasyManua.ls Logo

AVE AF997 - AF53907 Introduction and Technical Data

AVE AF997
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- 28 -
INTRODUCTION
AF53907 is a wall-mounted 7-zone burglar alarm control panel housed in a modular enclosure which
permits its installation both in electrical boards (overall dimensions 12 DIN modules) and in walls. The 7
zones have NC inputs; the alarm detectors can be connected to these directly by wire. By setting up the
C2 zone appropriately, it can be used as a 24h line for the connection of technical alarm detectors A
tamper line is also foreseen to protect all the external elements.
The mechanical key, located on the front face permits the system to be connected and disabled. A
pushbutton is provided to permit exclusion of the individual zones, so that the system can be partially
enabled. A remote activation point, code AF45342, can also be connected, which through the electro-
nic key AF45339, permits connection, disconnection and zoning from a remote position. The control
panel is complete with an internal power supply unit that powers the detectors, charges the batteries of
the outdoor self-powered siren and charges the back-up battery. This latter, inside the control panel,
powers the system in the event of mains failure.
TECHNICAL DATA
Enclosure: White ABS (210x125x58) mm
• Power supply: 230Vac –15% + 10%
• Maximum mains voltage rating : 80 mA
7 NC-type alarm zones (A1, A2, A3, B1, B2, C1, C2)
C2 zone can be programmed for technical alarms
NC-type tamper line
Built-in mechanical key
1 pushbutton for zone exclusion
Possibility of connecting an external electronic key for inserting/zoning
Entrance time, referred to zone A1, adjustable through micro-switches: 2-20-40-60 s.
Auxiliary open-collector alarm output to control a telephone dialler
Output for self-powered siren control. N.C. contact normally connected to V +
Output for auxiliary siren control. N.O. contact normally connected to V+ in alarm conditions
Open-collector output for technical alarms, referred to zone C2
Internal power supply unit with two outputs:
– 13,8vdc for system power supply
– 14.5vdc for outdoor self-powered siren battery
Maximum current the power supply unit can deliver: 280mA
Battery: 12v / 1.2Ah Pb composed of 2 sealed lead-acid 6V elements code AF910.
Climatic conditions
The requirements and performance of the control panel according to the CEI 79-2 standard are assu-
red under the following climatic conditions:
Reference temperature and relative humidity: 25°C – 65% RH
Operating room temperature range: -10°C to +50°C
Maximum relative humidity: 90% at +35°C
Altitude: 2000m a.s.l.

Related product manuals