LEVEL OWNER’S MANUAL
16
27
Motor Lock
Protection
Hub Motor
Encounters Resistance
Remove the bike from the obstacle,
power o, and power on again to
resume riding.
28
Low
Voltage
Voltage Too Low
to Operate
The voltage supplied by the battery is
too low to operate the bike. Charge
the battery and try again. If the issue
persists, check the voltage output on
the battery terminals using a volt meter.
If a fully-charged battery does not
output the correct voltage on the volt
meter, battery needs to be replaced.
29
Over
Voltage
Battery Supplying Too Much
Voltage to Controller
Make sure you are using the correct
battery for your bike. For example, the
48V Pace 500 battery cannot be used
to power the 36V Pace 350 ebike, even
though they look similar.
30
E1E
Communication
Error
Controller Has No or
Poor Connection to Display
Check all cable connections between
the controller and the display and that
the connectors are undamaged and not
contaminated with grit. If this does not
resolve the issue, replace the display. If
the bike does not work correctly with a
new display, replace the controller.
To Next Page
Loading...
