AVer CAM520 Pro2 - Page 12

4



Camera will track people while
moving. It will start to focus and
zoom in once people stop moving
for 1~5 seconds, depending on the
framing speed you choose.

Preset Framing: Set up preset
points in advance (Only for Preset
points 1~9. Preset 0 is for home
position). Camera tracks one
presenter and shoots the preset
areas instead of focusing and
zooming into presenter.
4. OSD Menu
To pull up OSD menu while using
HDMI out function. Not supported for
CAM520 Pro2.
5. Zoom In/Out
Increase/Decrease the camera zoom.
6. Preset
The Preset button on the remote
serves 2 functions.
To Save a Preset – Move camera to
desired position. Press and hold the
preset button until you receive the
save message on the screen. Select
preset position button 0-9 to store the
current camera position. Repeat steps
if needed.
To Load a Preset - Press the preset
button and preset position button 0-9
to load a saved camera position.
Repeat steps if needed.
7. Preset Position/Number
Buttons
Preset position buttons are used in
conjunction with the Preset button to
save positions. There are a total of 10
presets.
Press the preset button first and then
press 0~9 for the camera to move to
the saved position.
[Notes]

Press and hold the number button