12
Wait for the application to finish the all channel scan
process or in the All Channel Scan dialog box, click Stop
to terminate the searching process.
When auto-scan stops the AVerTV USB application will
return to the first memorized channel.
Skipping Unwanted Channels
If you want to exclude the selected channel, do the following:
1. Click the Video Configuration button.
2. In the Channel Setup dialog box, CH column, double-click
the selected channel you want to exclude (see figure
below).
Selecting a TV Channel
There are three ways you can select a desired TV channel:
1. Click the Channel Up/Down buttons until you
reach your desired channel (see figure at the right).
2. Click on the Number buttons to get your desired
channel number. To display the number pad of the
TV Control Panel, click CH# button.
3. Click the Video Configuration button.
In the Channel Setup dialog box, channel list, simply click
on the desired channel.
You will need to perform fine-tuning only if reception of
the selected channel is not clear. Adjust the Fine Tune
slider to get a clear TV picture.
To Next Page
Loading...
