19
3INSTALLATION AND DEINSTALLATION
2.1 UNPACKING, ASSEMBLING AND CONNECTING THE MACHINE
ALS
20X
256
V-shaped dispensing edge
Tool:
– 8 mm hexagon socket driver
Mount V-shaped dispensing edge as shown
– The angle of the V-shaped dispensing edge cannot
be changed. It is mounted without fixing pins.
Adjustable dispensing edge holder
Tool:
– 8 mm hexagon socket driver
The standard dispensing edge holder can be replaced
by the optional adjustable dispensing edge holder [15],
which enables a height adjustment of the dispensing
edge.
– Adjustment range: 70 mm in steps of 0.2 mm [17]
– Mounting is possible in different angles in steps of
15°, as with the standard dispensing edge holder
– Article no.: RH A8018, LH A8138
Adjusting:
Rotate the adjustment wheel [15A], until the inten-
ded height is reached.
[17] Adjustment range of the adjustable dispensing edge holder.
[14] V-shaped dispensing edge in place.
[15] Adjustable dispensing edge holder.
A Adjustment wheel
B Spindle
[16] Adjustable dispensing edge holder in place.
To Next Page
Loading...
