Avery Dennison AP5.4 - Arrangement of the Connections

05/09 Rev. 5.02-01 USER MANUAL Setup & Operation
AP4.4 – AP5.4
12
Arrangement of the Connections
For information about using the network connection, please read topic section
Advanced Applications .
[12] Back view of the AP 5.4 with mounted I/O board (accessory).
A Start/stop signal input:
(Optional) Connection for a treadle switch (signal starts the printer) or a
stacker (signal stops the printer).
B Serial Interface:
RS232 or RS422/485, on the optional available I/O board.
C Signal interface:
4 inputs / 3 outputs, belongs to the optional available I/O board.
CAUTION! - Additional equipment of poor quality can damage the printer
« Connect only devices that fulfill SELV circuit requirements to EN60950.
« Connect only original accessories.
A
B
C
D
E
F
G
H
I
J
KL