Avery Dennison AP5.4 - Configure Dispenser; Operation in Offline Mode

05/09 Rev. 5.02-01 USER MANUAL Setup & Operation
AP4.4 – AP5.4
21
Configure Dispenser
Application A The label is dispensed so that a small portion still sticks to the backing paper
above the dispensing edge. After the dispensed label has been removed by
hand, the next label is immediately printed and dispensed.
« Set DISPENSER PARA > Dispenseposition to –6.0mm (set to –8.0mm if the ma-
terial is very adhesive).
« Set DISPENSER PARA > Start Source to Light barrier .
Application B The printing and dispensing of the label is triggered by a signal from the foot
switch connected.
« Set SYSTEM PARAMETER > External Signal to Stacker full.
« Set DISPENSER PARA > Dispenseposition to –6.0mm (set to –8.0mm if the ma-
terial is very adhesive).
« Set DISPENSER PARA > Start Source to Foot switch .
Label length
< 40 mm
¯ If very short lables are supposed to be printed (PRINT PARAMETERS > Material
length is set to a value < 40mm), the printer performs automatically a material
initialization, which improves the impression accuracy of the printout.
More details can be found in the description of parameter DISPENSER PARA >
Calibration mode in topic section „Info-Printouts and Parameters“.
Operation in Offline Mode
• Switching from offline mode to online mode:
• Switch to online mode when the print job is stopped:
• Slow material and ribbon feed:
• Material travels backwards under the printhead:
• Reset:
• Access the parameter menu:
OFFLINE x JOBS
ONLINE x JOBS
OFFLINE x JOBS
Stopped xx
ONLINE x JOBS
Stopped xx
OFFLINE x JOBS
OFFLINE x JOBS
feeding…
OFFLINE x JOBS
OFFLINE x JOBS
feeding…
OFFLINE x JOBS
OFFLINE x JOBS
OFFLINE x JOBS
PRINT INFO
Online
Online
Feed
Online
Cut Online
Cut Online
Feed
Prog