1-2 Operator's Handbook
Using this Manual
Following is a summary of the contents of this manual:
Chapter Contents
1 Introduction Information you should know before using the printer.
2 Using Batteries Charging, changing, and using batteries safely.
3 Using Supplies Supply loading.
4 Entering and Printing Data Using the display, keypad, scanner, and printing.
5 Care & Maintenance Clearing supply jams and cleaning the printer.
6 Troubleshooting Common problems and solutions.
A Specifications & Accessories Printer specifications and accessories/options.
Audience
This manual is for the operator who scans or manually enters data and prints and applies labels.
Getting Started
To start using the printer, you must:
1. Review the safety information in the Regulatory Compliance document provided with your
printer.
2. Charge the main battery. See “Charging the Main Battery” in Chapter 2 for more information.
Note: You must charge the battery before using it.
3. Insert the main battery. See “Changing the Main Battery” in Chapter 2 for more information.
4. Load supplies in the printer. See “Loading the Supplies” in Chapter 3 for more information.
5. Turn on the printer.
Note: Your System Administrator must load an application in the printer before you can use it.
Helpful Reminders
Always start with a fully charged battery.
When you load a new roll of supplies, check the main battery’s printing power, if it is low,
switch to a fully charged battery (doing so ensures optimum print quality).
Turn off the printer when you are not using it.
Do not pound the printer when applying labels printed in peel mode.
Operate and store the printer with the recommended temperature and humidity ranges.
See Appendix A, “Specifications and Accessories,” for more information.
To Next Page
Loading...
