AVI AVI61006 - System Connections; Connecting External AV Sources; Connecting TV Signal Input

- 13 -
Remote Control
23. +10 Button
Select numbers greater than 9 by
pressing the (+10) button first, and
then additional number buttons are
needed.
24. TIME Button
In standby status, the time is still
displayed on the panel.
Press it to set the time on the
display panel. Use the ,buttons
to select the editing position of hour
or minute, and then use the ,
buttons to adjust the value of the
hour or minute downward and
upward.
25. SETUP Button
Press to enter the DVD setup menu
in the DVD mode
Or press to enter the DVB-T system
setup menu in DVB-T mode.
26. INFO Button
Press to display detailed playback
information under DVD or DVB-T
mode.
Press repeatedly to display
additional information or to turn the
information display off.
27. LCD ON/OFF Button
Press to turn the LCD screen
display On or Off.
28. LCD SETUP Button
Press once to enter the PICTURE
setup menu. Then press the
Xbutton to enter the TV SETUP
menu in TV mode.
29.

NEXT Button
Press to go to the next track under
DVD mode.
Press it when the function can be
displayed by the BLUE button
according to the indication on the
menu under the DVB mode.
30.

PREV Button
When a DVD disc is playing, press
once to go to beginning of current
track/ chapter. Press twice
repeatedly to go to beginning of
previous track or chapter.
Press it when the function can be
displayed by the YELLOW button
according to the indication on the
menu under the DVB mode.
31. MUTE Button
Press to turn on/off the speaker
output. The corresponding
information will be displayed on the
display panel.
32.

(PAUSE) Button
Press to pause playback in DVD
mode.
33. ZOOM/P+ Button
Press to enter and cycle through
zoom functions when playing DVD
disc, use the direction buttons to
pan around the screen when
zoomed in.
Press to select the channel forward
in the EPG setup.
34. VOL+/ - Buttons
Press to increase or decrease the
speaker volume level.
35. A-B/P- Button
Used to play a section of the DVD
disc from point “A” to point “B”.
Press once to select the starting
point (A), press again to select the
end point (B). Press the third time
to stop the A-B repeat mode.
Press to select the channel
backward in the EPG setup.