Chapter 4: Final Cut Pro 15
Chapter 4: Final Cut Pro
Configuring Final Cut Pro to operate with the Artist media controllers is simple.
1 In Final Cut Pro, choose Tools->Control Surfaces.
The Control Surface Configuration dialog opens.
2 Select Euphonix from the Use drop-down menu.
You will see the Euphonix logo with the message in the figure, above.
3 Press OK.
The Artist media controllers connect and update automatically. When you open your audio mixer your Euphonix media con-
troller(s) will control Final Cut Pro.
Your Artist media controller should now be controlling your application. If not, make sure Final Cut Pro is the front-most appli-
cation (i.e., the one receiving keystrokes and mouse clicks). The Artist media controllers control only the front-most application.
Control Surface Configuration Dialog
To Next Page
Loading...