EUCON Application Setup Guide44
Tips and Shortcuts
Assign and Control Plug-ins
Placing plug-ins on a track and controlling them from the Artist Series media controller can speed up your workflow. Controlling
a plug-in with knobs instead of a mouse not only provides more intuitive, higher resolution control, but can also control multiple
parameters simultaneously. You can dial in settings or automate plug-in control without mousing around or drawing lines in the
arrange window.
1 Select a track on the Artist media controller.
2 Press the INSERTS key (MC Mix) or the INSERTS Knob Top (MC Control).
3 Press both PAGE keys simultaneously to enter Config mode.
4 Push the Knob Top beside the Insert you wish to assign the plug-in to.
5 Push the type for the type of plug-in you wish to instantiate.
6 Press the Knob Top to select the actual plug-in.
7 Press the Knob Top to select the channel format.
8 Press both PAGE keys simultaneously to exit Config mode.
9 Push the Knob Top to open the plug-in.
10 Control plug-in parameters; press the PAGE keys to access more.
11 Press the BACK key to close plug-in.
Wheel Edit Modes (MC Control)
Use the Jog Wheel to trim the head/tail of a region, move a region, or slip audio in a region without clicking and dragging with
the mouse.
1 Select a track on the Artist media controller.
2 Select a Region on the track.
3 Touch the Softkeys button on the Touchscreen to display Softkey view.
4 Press Editing on the Touchscreen.
5 Zoom into the region.
6 Touch Region on the Touchscreen to trim head and tail with Jog Wheel.
7 Adjust nudge value with Nudge + and Nudge - on the Touchscreen.
To Next Page
Loading...
Need help?
General
