Appendix A: Pro Tools (HUI) 45
Create and Use Wheel Nudge
Scroll your Artist Series media controllers through the Pro Tools tracks in the session you wish to control with the Jog Wheel. This
is much like moving a chair into the proper position in front of a large console.
1 Open the Softkey editor.
2 Select a Softkey in the editor.
3 Press the Command button.
4 Add a EuCon command
5 Click the drop down list and select the WHEEL command.
6 Select the MC Control Jog wheel in the top drop-down on the right hand side of the command editor.
7 Select Left Edit > Nudge in the bottom drop-down menu.
8 Save the command and exit.
9 Change the focus to Pro Tools.
10 Open the Mix window by pressing SHIFT + <NUDGE (mixer nudge).
11 Press the Nudge button you've just created.
12 Use the Jog Wheel to nudge through tracks.
EQ Knobset
The EQ knobset can control settings for four parametric EQ bands and access Q and band On/Off from the knobs.
1 Enter the INSERTS knobset, create Digirack EQ, and exit the INSERTS knobset.
2 Press the EQ button (MC Mix) or EQ Knob Top (MC Control).
3 Use the knobs to control EQ bands.
4 Press the ON button to toggle bands on/off (MC Mix). Press the Touchscreen GAIN button to toggle bands on/off (MC Control).
5 Press the Select button to toggle Freq/Q (MC Mix). Press and hold the Shift key and press FREQ on the Touchscreen to toggle
Freq/Q (MC Control).
6 Press the BACK key to exit.
DYN Knobset
Quickly edit Digirack Dynamics plug-in parameters.
1 Create a Digirack compressor and exit the INSERTS knobset.
2 Press DYN button (MC Mix) or DYN Knob Top (MC Control).
3 Use knobs to control compressor parameters.
4 Press the BACK key to exit.
To Next Page
Loading...
Need help?
General
