S6L Control Surface RAM Expansion 15
4 Carefully lift the first RAM module out of its slot and set it aside.
5 Repeat to remove the lower RAM module.
6 Carefully install a new RAM module in the lower slot.
• Make sure to first seat the module fully into its connector.
• Gently push the RAM module down until it snaps into position secured by its retaining clips.
7 Repeat to install the second, upper RAM module.
8 Proceed to Reinstall the SBC Tray.
Reinstall the SBC Tray
To reinstall the SBC Tray:
1 Use a #2 Phillips screwdriver to re-install the shroud by replacing the 3 fasteners that secure the shroud to the Tray.
2 Lift the Tray off the edge of the chassis and carefully re-insert it into the chassis.
Angle it in as necessary. Use one hand to keep cables clear while using the other hand to angle the Tray in.
3 Double-check that you have reconnected any SBC cables you might have disconnected to make room for the AVB assembly.
4 Make sure the Tray is fully seated in the chassis and that the tabs protruding up from the chassis align with and fit into their slots
in the bottom of the Tray.
5 Using a #2 Phillips screwdriver, secure the Tray to the chassis by tightening the captive screws you loosened earlier (including
the one accessible through the hole in the shroud).
6 Using a #2 Phillips screwdriver, re-install the two screws that secure the top of the shroud to the chassis.
7 Proceed to Complete the Installation.
Figure 32. Removing a RAM module
To Next Page
Loading...
Need help?
General
