Avid Technology S6L Control Surface Installing

S6L Control Surface RAM Expansion 3
3 After removing the fasteners try sliding the back cover off the chassis by pushing it down with your hands and simultaneously
pulling the cover away from the chassis. If the cover does not slide freely, do the following:
• Try inserting a small flathead screwdriver along its upper edge as shown in
Figure 1 to work one side free and then the other.
• To be able to remove the back cover without risking scratching the chassis, first remove both end caps. (At minimum, one End
Cap needs to be loosened enough to let you remove the top cover later in these instructions. If you remove either (or both) of
the End Caps completely, carefully disconnect the LED power cable before moving the cap(s) away from the chassis.)
• Next, use a #2 Phillips screwdriver and remove one of the small retaining brackets.
4 Slide the panel away from the control surface, and set the panel aside.
S6L-24C, S6L-16C
To remove the covers from S6L-24C or 16C:
1 Make sure you have shut down the system and that all components are powered off.
2 Using a 2.5 mm Hex driver, loosen or remove both the right and left End Caps by loosening the 7 fasteners securing the caps to
the chassis. At minimum, one End Cap needs to be loosened enough to let you remove the top cover later in these instructions.
If you remove either (or both) of the End Caps completely, carefully disconnect the LED power cable before moving the cap
away from the chassis.
Figure 2. End Cap and fasteners
Figure 3. Retention bracket and fasteners
Figure 4. End Cap fasteners
Fasteners:
Tool:
M4x8mm BHCS
2.5mm Hex driver
Fasteners:
Tool:
M3x6mm Phillips
#2 Phillips screwdriver
Fasteners:
Tool:
M4x8mm BHCS
2.5mm Hex driver

Avid Technology S6L Control Surface Specifications

General

Brand	Avid Technology
Model	S6L Control Surface
Category	Music Mixer
Language	English