S6L Control Surface RAM Expansion 7
Remove the SBC Tray
The SBC Tray must be removed from the chassis before you can access and replace the RAM modules, which are located below
the purple plastic shroud.
The exact steps differ slightly between D-series and C-series S6L control surfaces. Follow the instructions appropriate for your
control surface:
•
Removing the SBC Tray in S6L-24D or 32D
• Removing the SBC Tray in S6L-16C or 24C
Removing the SBC Tray in S6L-24D or 32D
To remove the SBC Tray:
1 If your system includes one, remove the black rubber stopper from the purple plastic shroud, and set it aside (you do not need
to re-install it). This stopper must be removed to access one of the captive screws that secures the SBC Tray to the chassis.
2 With the stopper removed, use a #2 Phillips screwdriver to loosen the captive screw below the stopper hole.
Early model control surfaces included this stopper; newer models do not.
Figure 9. Shroud with stopper removed, showing captive screw below
Figure 10. Loosening the captive screw below the shroud
To Next Page
Loading...
