WEAT C2 N - V1
Caution for or the safety of individuals and property, follow these instructions and keep them in a
safe place.
We recommend you carefully read and follow these instructions. Improper use and programming can be
dangerous and can cause serious injury.
If you are unsure about installing this product, seek assistance from our technical department.
This symbol is used to highlight points that could be a potential source of danger. Ensure procedures
and safety standards in force in the installation country are followed.
This system complies with the essential requirements and other provisions of the 1999/5/CE directive.
The installation of an automated gate or garage door system must comply with the 98/37/CE “Machinery
Directive” and particularly with the
EN 12445:2001; EN 12453:2001; EN 12978:2003; EN13241-1:2003
standards. These standards allow the compliance of an automated system to be declared.
This automated system must be installed, commisioned and maintained by qualified and specialised
individuals.
a - WARNING
- Analyse the risks of your installation, make a list of the essential safety requirements in appendix I of the
machinery directive.
To complete this document, you can, if required, contact a professional installer.
- The manufacturer of this automated system will not be held responsible if installation and usage guidelines are
not followed.
- Improper installation or adjustment can cause serious injury to users or to the installer.
- The following warnings are an integral and essential part of the product and must be provided to users.
- Read these warnings carefully because they provide important information about installation, use and
maintenance.
- Keep this manual and give it to individuals who will use the installation when you no longer use it.
- Incorrect installation or improper use of this product could be very dangerous.
- The manufacturer will not be held responsible for the integrity of the product, and for the safety and
operation of it, if incompatible devices and/or components are installed.
- For the repair or construction of parts, original replacement parts must only be used.
- The installer must provide all information regarding the functioning, maintenance and use of each of the parts
and the overall system.
- The installation, electrical connections, and adjustments must be professionally done by a qualified and
specialised individual.
b – CORRECT PRODUCT SELECTION
Check that the product for residential use that you have purchased suits your existing gate and that you have all
the necessary parts to ensure “safety”. Particularly check the technical features (weight and size of the gate, full
or open-work, sliding or stable door etc.)
You must have all the parts to ensure “safety” either in the kit or in option (for example the sensor bar for
open-workl sliding doors)
If you are unsure, contact a professional.
c – CHECK THE CONDITION OF YOUR GATE
Make sure that your gate can support your automated system, by checking the solidity of hinges or sliders, that
the structures are able to take the screwed and moveable automated system parts, that the clearance area is
clear and well visible, that it is in general good condition and that it opens and closes easily when you use it ma-
nually….
1. GENERAL SAFETY INSTRUCTIONS
To Next Page
Loading...