12
LED Indicators
Once the dome camera is connected to the network, the camera’s connection status
LEDs will display the camera’s progress in connecting to the Network Video
Management software. The following table describes what the LEDs indicate:
Table 2: LED Indicators
Connection
State
Connection
Status LED
Description
No Link Off Usually indicates that the dome camera is not
physically connected to any network device.
Obtaining IP
Address
One short flash
every second
The dome camera is attempting to obtain an
IP address.
Connecting to
NVR
Two short flashes
every second
The dome camera has obtained an IP address
and is ready to be connected.
Upgrading
Firmware
Two short flashes
and one long flash
every second
The dome camera is updating it’s firmware.
Connected On The dome camera is connected to the
Network Video Management software.
To Next Page
Loading...
