3. Fasten the junction box to the mounting surface.
Note: To prevent moisture from entering the junction box, it is recommended to apply teflon
tape around the threaded conduit pipe at the cable entry point of the junction box. Ensure the
other two conduit plugs are fully tightened.
4. Insert the mounting hooks on the rear of the camera into the mounting hook slots on the junction box,
then let the camera hang.
Note: Before connecting any cables, ensure that the cable connections are properly
protected from moisture and corrosion. Make sure the protective cable boot is installed over
the Ethernet port to protect the connection from dust and moisture.
Mounting the Bullet Camera 11
To Next Page
Loading...
