1. Define the motion detection area.
The entire field of view is highlighted for motion detection by default. To define the motion detection
area, use any of the following tools:
l Click Clear All to remove all motion detection areas on the video image.
l Click Set All to set the motion detection area to span the entire video image.
l To set a specific motion detection area, click Select Area then click and drag anywhere on the
video image.
l To clear a specific motion detection area, click Clear Area then click and drag over any motion
detection area.
l Use the Zoom In and Zoom Out buttons to locate specific areas in the video image.
2. In the Sensitivity field, enter a percentage number to define how much each pixel must change before it is
considered in motion.
The higher the sensitivity, the smaller the amount of pixel change is required before motion is detected.
3. In the Threshold field, enter a percentage number to define how many pixels must change before the
image is considered to have motion.
The higher the threshold, the higher the number of pixels must change before the image is considered to
have motion.
4. Click Apply to save your changes.
Privacy Zones
On the Privacy Zones page, you can set privacy zones in the camera’s field of view to block out areas that you
do not want to see or record. The camera supports up to four privacy zones.
1. To add a privacy zone, click Add. A privacy zone box is added to the video image.
2. To define the privacy zone area, perform any of the following:
a. Drag the bottom or right side of the box to resize the privacy zone.
NOTE: Privacy zones can only be rectangular in shape.
b. Click the center of the box then drag to move the privacy zone.
c. Click the X at the top right corner of the gray box to delete the privacy zone.
3. Click Apply to save the privacy zone settings.
4. If you are using a PTZ camera, a list of privacy zones is available at the bottom of the page. When you
click one of the privacy zones, the camera moves and highlights that privacy zone in the image panel.
Storage
On the Storage page, you can enable the camera’s onboard storage feature and download recorded video
directly from the camera.
14 Privacy Zones
To Next Page
Loading...
