Avigilon ACC VMA-RPO-4P2 - Manage ACC Services; Enable ACC Client Users to Archive Video

Manage ACC Services
On the Server panel use the:
l General pane:
To... Do this...
Shut down all the services before you shut
down the device.
Click Stop.
Start up all the services after they have been
shut down.
Click Start.
Reset the ACC ES HD Recorder Click Reset
Format the storage drive. Click Reinitialize to delete all configuration and
recorded video data.
l Network Storage Management pane to enable ACC Client application users to archive video from
the ACC ES HD Recorder. See Enable ACC Client Users to Archive Video below
l Service and RTP Ports panes to change the UDPand TCP ports used to communicate with the ACC
ES HD Recorder:
l In the Service Ports pane, enter the Base value to use for the HTTP, HTTPS, and UDPports and
click Apply. The list of ports is updated.
l In the RTP Ports pane, enter the Base value to use for the UDPports and click Apply. The
range of ports available for RTP is updated.
Important: These changes can only take effect after the system restarts. When you are
prompted, allow the system to restart.
Enable ACC Client Users to Archive Video
To allow users of the ACC Client application to archive video from the ACC ES HD Recorder:
1. From the navigation bar, open the Server panel.
2. In the Network Storage Management pane, click Enabled
3. From the Protocol drop down list, select one of the following:
l CIFS — Common Internet file system. The network path is typically in this format: //<hostname
or IP> / <path>
l NFS — Network file system. The network path is typically in this format: <hostname or IP> :
<path>
4. In the Network Path field, enter the path to the preferred video archiving location.
5. If the network location requires authentication, enter the credentials in the Username and Password
Manage ACC Services 8