Avigilon ACC VMA-RPO-4P2 - Assigning a Poe Power Budget

Note: The corporate network and the camera network must be on different IPsubnets.
The corporate network is the network that typically provides users with access to the device. Users who
monitor video through the ACC Client software connect to the device through this network.
The camera network is a closed network that typically only contains cameras. This reduces the amount of
interference with video recording.
When connecting an ONVIF device to the camera network, configure it to use the appliance as its time/NTP
server.
For more information about the network connections, see Supported Network Configurations on page3.
You can perform any of the following actions in each of the panes in the Network panel:
To... Do this...
Set how the
device obtains an
IP address for
each network.
Toggle Automatic IP on to discover connected networks automatically (the default
setting), or off to manually specify the connections. Enter the appropriate values in
the following fields if you are manually entering the connection settings:
In each of the panes in the Network panel, toggle Automatic IP on to discover
connected networks automatically (the default setting), or off to manually specify the
connections. Enter the appropriate values in the following fields if you are manually
entering the connection settings:
l
IP Address
l
Subnet Mask
l
Default Gateway
Click Apply to save your changes.
Set how the
device obtains a
named address
from a DNS
server.
Toggle Automatic DNS on to discover connected DNSservers automatically (the
default setting), or off to manually specify the DNSservers. Controls to add and
delete addresses in the list, and reorder them are activated when Automatic DNSis
toggled off.
Assigning a PoE Power Budget
Use the PoE panel to see how much power is available to, and being used by, connected devices. The
default setting for all ports is Auto. This setting automatically detects and budgets the amount of power
required by the device connected to the port. For each port you can adjust this setting manually, or turn off
power output completely. If you want to manually adjust the power output of the ports you must calculate a
PoE power budget, see Budgeting PoE Power on page22.
Assigning a PoE Power Budget 12