Avigilon ACC VMA-RPO-4P2 - Manage Storage; Connect the Device to Cameras and ACC Client Users

1. Select your Time Zone from the drop-down list. The time zone that you set here is used by the
recording schedules defined in the ACC Client software.
2. Select whether you want to keep synchronized time through a Network Time Protocol (NTP) server
(recommended) in the NTP field.
Select:
l DHCP to automatically use the existing NTP servers in the network.
l Manual to enter the address of NTP servers in the Servers list. Controls to add and delete
addresses in the list, and reorder them are activated.
l Off if you do not use an NTP server.
Note: The default set of NTP servers is always present in the Servers list. However, this list is
only used if NTP is enabled and not provided by your DHCP server. The default list cannot
be rearranged or deleted.
l 0.pool.ntp.org
l 1.pool.ntp.org
l 2.pool.ntp.org
l 3.pool.ntp.org
3. Click Apply to save the time settings.
Manage Storage
On the Storage panel you can view the storage capacity of the device and the status of the storage drive on
ACCES4- and 8-port appliances (or drives on older 4-port ACCESappliances).
Click Storage on the navigation bar to open the Storage panel. You can perform any of the following actions
in the pane in the Storage panel:
To... Do this...
View the capacity and status of
the storage drive.
On the Physical Disks panel, information about each physical disk,
including its model and serial number is listed.
When the storage drive is:
l Correctly working, Ready is displayed.
l Not correctly working, one of several error states is displayed.
Connect the Device to Cameras and ACC Client Users
On the Network panel, you can change network connections of the device. Two network connections are
supported: one for a corporate network and one for a camera network.
Manage Storage 11