Resetting to Factory Default Settings
If the camera no longer functions as expected, you can choose to reset the camera to its factory default settings.
Use the firmware revert button to reset the camera. The firmware revert button is shown in the following diagram:
If you have video recorded to the SD card, be aware that resetting the camera will not affect the recorded video.
Figure 3: The firmware revert button on the dome camera.
1. Ensure the camera is powered on.
2. Using a straightened paperclip or similar tool, gently press and hold the firmware revert button.
3. Release the button after three seconds.
CAUTION — Do not apply excessive force. Inserting the tool too far will damage the camera.
20 Resetting to Factory Default Settings
To Next Page
Loading...
Need help?
General
