Resetting the iDRAC System
To reboot the iDRAC web interface without rebooting the operating system:
1. Go to the front left panel of the recorder.
2.
Press and hold the system health and system identification button for 16 seconds until the cooling
fans start spinning at full speed.
The iDRAC system restarts without changing any saved settings. It may take a minute or longer until
the remote controller restarts.
For information about using the iDRAC web interface to perform the reset, see the Enabling iDRAC
Enterprise Features Setup Guide.
Limited Warranty
Avigilon warranty terms for this product are provided at avigilon.com/warranty.
Resetting the iDRAC System 18
To Next Page
Loading...