Installation
Connect the Cables and Power On
Refer to the diagrams in the Overview section for the location of the different connectors. Make the following
connections as required:
1. Connect a KVM switch or separate keyboard, mouse and monitor to the recorder.
l
The keyboard and mouse can be connected to any USB port on the recorder.
l
The monitor can be connected to any video connector at the front or back of the recorder.
2. Connect the recorder to your network by plugging an Ethernet cable into one of the Ethernet ports.
3. Connect a power cable to the power supply at the back of the recorder.
4. Press the power button on the front of the recorder and wait for it to start up. Check that the recorder
LED indicators display the correct status. For more information on the different LED status indicators,
see LED Indicators on page14.
Install the Bezel
The bezel can be installed on the front of the recorder to help protect the hard drives against unauthorized
access.
1. Align and insert the right end of the bezel until it clicks into place.
2. Push the left end of the bezel into the front of the unit until it clicks into place.
3. Use the provided key to lock the bezel.
Installation 4
To Next Page
Loading...