5 Commissioning
5.1 Hardware
Site of Installation
The device should be installed on the workshop floor. If the device is used in another position (e.g.,
placed on shelves or other constructions), the device must be secured against dropping.
Make sure that the installation site meets the following requirements:
• The device must not be exposed to direct sunlight.
• The device must not be exposed to excessive heat.
• The power supply connection must be freely accessible.
• Do not place the device directly next to the exhaust.
The device must not be operated near open fuel tanks, as otherwise there is a risk of explosion or
fire due to gases and/or vapours.
To Next Page
Loading...
