Checking the Data of the WLAN Connection
37
Checking the Data of the WLAN Connection
Changing the Position of the WLAN Devices
Could not register at the WLAN remote site.
Possible Cause
The settings of the WLAN remote site and the entries in the
“WLAN Remote Site” window of the FRITZ!WLAN control soft-
ware do not match.
Remedy
Check whether the correct WLAN access point has been select-
ed from the list of WLAN devices and make sure that the WLAN
key and the name (SSID) of the WLAN remote site have been en-
tered correctly. Pay special attention to capitalization.
For a WLAN product from the AVM FRITZ!Box family, the default
name always begins with “FRITZ!Box”. On AVM FRITZ!Box prod-
ucts, the WLAN key is printed on the underside of the device
and on the installation CD jewel case.
If you are using a WLAN access point from another manufactur-
er, please see the documentation of this device.
In a direct connection, the preconfigured name of the ad-hoc
network in the FRITZ!WLAN control software is “ad hoc”.
Then connect with the WLAN remote site again.
No WLAN remote sites are found.
Possible Cause
The WLAN remote site has not been turned on or is located too
far away from the FRITZ!WLAN USB Stick.
Remedy
Make sure that the power supply of the WLAN remote site is se-
cure and that the device is switched on.
Check whether the WLAN remote site is within transmission
range of the FRITZ!WLAN USB Stick. Reduce the distance and try
to establish the connection again.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
