AVM FRITZ!WLAN USB Stick Installation, Configuration And Operation

38
Installing the Patch for WPA2 with Microsoft WLAN Service
Installing the Patch for WPA2 with Microsoft WLAN
Service
7.3 Errors During Data Exchange with Other Devices in the Network
Checking the WLAN Access Point
The WLAN connection to an access point cannot be established
using the Microsoft WLAN Service (WZC) in Windows XP with
Service Pack 2.
Possible Cause
The required Microsoft patch for WPA2 (IEEE 802.11i) may not
be not installed.
Remedy
Support for WPA2 in Microsoft WLAN service was not available
until the current patch for Windows XP Service Pack 2. Install
the current patch from Microsoft:
support.microsoft.com/kb/917021
Alternatively, you can install Service Pack 3 instead.
The FRITZ!WLAN USB Stick and the WLAN access point cannot
exchange any data with each other.
Possible Cause
The WLAN access point is not connected correctly or not
switched on.
Remedy
Check whether the WLAN access point is connected correctly
and make sure that the device and the WLAN function are
switched on.

AVM FRITZ!WLAN USB Stick Specifications

General

Wi-Fi	Yes
Wi-Fi band	Single-band (2.4 GHz)
Data link protocols	IEEE 802.11b, IEEE 802.11g, IEEE 802.11g++
Security algorithms	WPA, WPA2
Maximum data transfer rate	125 Mbit/s
Dimensions (WxDxH)	132 x 138 x 35 mm
Compliance industry standards	IEEE 802.11b, IEEE 802.11g, IEEE 802.11i
Supported data transfer rates	11 Mbit/s, 54 Mbit/s, 125 Mbit/s
Compatible operating systems	Windows Vista x64 Edition, Windows Vista, XP Professional x64 Edition, Windows XP/2000
Connectivity technology	Wireless
Component for	PC/Laptop

Weight and Dimensions

Weight	125 g