14
Installation in Windows XP 32-bit Edition and Windows 2000
8. Insert the FRITZ!WLAN USB Stick CD when Windows
prompts you to do so.
The driver software is installed automatically.
This completes the driver installation for the
FRITZ!WLAN USB Stick. Continue reading from section “In-
formation on WLAN Connections” on page 16.
3.3 Installation in Windows XP 32-bit Edition and Windows 2000
Administrator rights are required to install the
FRITZ!WLAN USB Stick in Windows XP and Windows 2000!
In order to install the FRITZ!WLAN USB Stick, perform the
following steps:
1. Switch on the WLAN device you wish to connect to.
2. Switch on your computer.
3. Insert the FRITZ!WLAN USB Stick into the USB port on
your computer.
Windows detects the FRITZ!WLAN USB Stick automat-
ically. This process may take some time.
4. The drivers and the control software for your
FRITZ!WLAN USB Stick are installed automatically.
If you are prompted to do so, insert the
FRITZ!WLAN USB Stick CD and follow the instructions
on the screen.
If an additional Windows dialog asks if you want to
install software not digitally signed by Microsoft,
click “Continue Anyway” (Windows XP) or “Yes”
(Windows 2000). This request depends on the driver
signature options set on your computer.
A progress bar indicates the progress and the conclu-
sion of the installation.
This completes the driver installation for the
FRITZ!WLAN USB Stick. Continue reading from section “In-
formation on WLAN Connections” on page 16.