16
Information on WLAN Connections
Information on WLAN Connections
If you performed installation using Stick & Surf, no further
steps are necessary to establish a WLAN connection. Your
FRITZ!Box WLAN will be identified automatically as WLAN
access point. A WLAN connection you can use immediate-
ly will be established.
If you performed installation without using Stick & Surf,
you have to select the WLAN remote site (the WLAN access
point) to connect with manually in your WLAN control soft-
ware. Please see the corresponding chapter of the control
software for more information:
If you are using the control software FRITZ!WLAN,
please continue by reading the section “Establishing
a Connection with a WLAN Access Point (Infrastruc-
ture Network)” from page 20.
If you are using Windows Vista’s Microsoft WLAN Ser-
vice, continue reading in the section “Establishing a
WLAN Connection (Windows Vista)” from page 25. If
you are using Windows XP’s Microsoft WLAN Service,
continue reading in the section “Establishing a WLAN
Connection (Windows XP from Service Pack 2)” from
page 26.