www.avmatrix.net
11
The selected PGM source will circled in red border, while the selected PVW source will be circled in green
border.
For example, switching the PGM source to SDI 1 and PVW source to SDI 2. The button selection as
below image. The default sources of PVW and PGM are SDI 1 and SDI 2 when the first turn the video
switch on. When operating the AUTO or T-Bar transition, the selection from PGM row and PVW row is
invalid, both LED indicators will turn red.
4.3.2 Transition Control
There are two transition control types for this video switcher: Transition without effects and Transition with
effects.
1) Transition without Effects
CUT performs a simple immediate switch between Preview and Program views. This is no delay
seamless switching and the selected transition effect WIPE, MIX or FADE is not used.
2) Transition with Effects
AUTO performs an automated switch between Preview & Program views. The speed of the
transition is set by the menu. The selected transition WIPE, MIX or FADE will also be used.
T-Bar transition effect performs same as AUTO, but speed depends on the speed of the manual switch.
To Next Page
Loading...
Need help?
General
