Trapeze wire
Shroud
Forestay pigtail (forestay of 15)
Shroud
Trapeze wire
Notes:
The
18
will
have double trapeze wires
on
one
thimble. When rigging forestay pigtail
onto
masthorn,
the short wire should be towards mast
on
16
&
18,
the
15
will
have the forestay wire only, no pigtail.
Shrouds
and
trapeze
wires
Attach twist clip to shroud pin
on
deck with
1/4"
clevis pin. Attach twist clip to
shroud
adjuster using
another
1/4"
clevis pin. To attach shrouds to shroud
adjuster, insert shroud thimble
in
between shroud
adjuster jaws
and
insert clevis pin through adjuster
and
shroud thimble. Use
one
of the upper holes
in
the
adjuster. Insert cotter ring.
Tie a trapeze ring to each of the
3'
lines supplied.
Thread
the
line through the thimble at the
end
of the
trapeze wire.
Thread
one
of the plastic height adjusters
onto
the line, wrapping the line
around
it
at least twice.
The
adjuster allows you to adjust your trapeze height.
Tie the tail of the line to the shock cord with a bowline.
Prindle
15
&
16
single trapeze
Prindle
18
double trapeze
Forestay
and
jib
halyard
15:
The
forestay
is
already attached to the mast-
horn
and
there
is
no jib halyard.
16
&
18:
Attach
the
forestay to the long pigtail
(30") with a
1/4"
shackle.
The
ring must face towards
the
masj.-
-13-
To Next Page
Loading...