EasyManua.ls Logo

Avon Prindle 15 - Section II: Sailing; Sail Trim to Weather

Default Icon
46 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Tum
the boat until the wind
is
blowing from a
45°
angle to the bow. Ease the traveler
out
to the lee side
and sheet the main
in
tight. Have your crew sit on the
trampoline to keep the mainsheet from uncleating and
the boat from tipping. With the main sheeted to
leeward, the leeward shroud
will
be
loose. Move the
shroud down a couple of holes on the adjuster, but not
all
the
way down. Replace clevis pin and ring. Loosen
mainsheet.
Tum
the boat so the wind
is
coming from the
opposite side. Ease the traveler out to what
is
now the
lee side .
and
sheet
in.
The new leeward shroud
will
be
loose. Move the shroud down to the corresponding
hole
in
the adjuster as the
first
shroud.
If
the rig
is
still
loose, move the shroud down
one
or
two more holes
and repeat with the other side until the
rig
is
fairly tight
and both shrouds are
in
the
same
hole
on
adjuster.
It
is
possible to over-tighten the rig which
will
make
the mast hard to rotate.
When you take the boat apart, be sure
to
loosen
one
side
only
before taking
the
main down.
By
leaving one shroud
in
the correct hole, you
will
only
have to tighten
one
side next time you go sailing.
If
you are not happy with the mast rake you have,
simply lengthen or shorten the forestay turnbuckle.
Be
sure
to
leave
at
least
10
complete
threads
into
each
side
of
the
barrel.
Section
II:
SAILING
SAIL
TRIM
To
Weather
The
main traveler should be centered with the main
and
jib
sheets
in
snug. Be careful not to pull the sails
in
too tight. If the main
is
oversheeted (too tight), the
mainsail
will
be
too
flat
and
the
boat
will
not move very
fast
If
the jib
is
oversheeted
it
will
stop the air flowing
between
the
leech of the
jib
and
the mainsail. This gap
(slot) between the jib leech and
the
mainsail should be
about
12
inches near the
top
of the
jib.
The
jib tell-tale on the leeward
and
windward sides
should be streaming back.
If
the
windward tell-tale
on
the jib
is
flopping forward you should
head
the boat
downwind a little.
If
the
leeward tell-tale
is
flopping
forward, you should head the boat up into
the
wind a
little or,
if
you do not want
to
head
up any further, let
the sail out a little.
-
26-

Related product manuals