Start the zipper
around
forestay wire
and
jib
halyard line.
The
jib halyard
is
internal in
the
luff of jib.
Hoist jib up, closing zipper as you do until" S"
hook
just passes ring.
Slowly pull the jib back down
at
the tack (forward
lower corner) until the hook
is
locked
in
place. Note:
the opening
on
hook should be between
1/4"
to
3/8"
for easiest operation.
Unlock the brummel hooks from each
other
and
store extra halyard length
in
one
of
the
pockets
on
trampoline.
Lead jib down haul line
around
shackle pin
and
cleat down haul line snugly into cleat
on
jib tack.
16: Attach two small pullies (attached to jib
sheet
line earlier)
to
foot of
jib
by leading each
one
around
to
the front of
the
mast,
one
from each side. Put a
1/4"
shackle through grommet
in
lower aft
comer
of
jib
(clew)
and
reattach pullies with shackle pin. Make sure
that
these
lines
are
not twisted. Pull up slack from line
leading between the
jib
sheet
blocks
on
trampoline.
18:
Tie jib clew blocks to sail clew rather than with
-24-
To Next Page
Loading...