Tie the block onto the side trampoline tab using a
square knot. Use tab just forward of hatch for single
trapeze and tabs just forward and aft of hatch for
double trapeze.
Slip tails of line
under
tab to hide
and
keep knot
from loosening. Blocks should stand straight up.
Lead shock cord through block, down through
grommet
by
hatch,
and
up through grommet
and
block
on
opposite side of tramp. Secure
end
until needed
later.
Attach a
3/16"
shackle onto each jib bridle wire. Be
sure pin handle
is
facing up
so
that
it
does not scratch
trampoline.
Tie
3/16"
x 6' line to
one
of the shackles and lead
the other
end
through
one
set of double grommets at
center of tramp.
Using a truckers hitch, tie the line to the
3/16"
shackle
on
opposite jib bridle wire. Pull line as tight as
possible
and
tie off using a row of half hitches.
-6-
To Next Page
Loading...