AVOURY One - Rinsing the Brewing Container; Making Tea

PAGE 11
USE
Rinsing the brewing
container
The tea maker must be cleaned out
before the rst use and after longer
periods of non-use to remove any
manufacturing residues and contamina-
tion. To do this, the tea maker must be
switched on.
1. Remove the packaging material and
the adhesive strips.
2. Remove the water tank
4
and
rinse it out with clear tap water.
3. Replace the water tank again.
4. Fill the water tank with water up to a
maximum level of two nger widths
below the upper edge.
5. Place a container that holds at least
300 ml volume under the outlet
8
.
6. Push the On/O button
9
.
7. Press the –/+ lling capacity
buttons at the same time
18
/
19
.
The tea maker rinses the brewing
container and dispenses water into
the container.
8. Empty the contents of the tray of
the pod catching drawer
7
and
the container into the sink.
Making tea
1. Remove the water tank
4
and ll
with water up to a maximum level of
two nger widths under the upper
edge of the water tank.
2. Switch on the tea maker.
3. Wait until the On/O button
9
is
illuminated constantly.
4. Place a cup under the outlet
8
.
The cup must be able to hold at
least 250 ml.
5. Remove the sealing lm from the
pod.
6. Open the pod compartment
2
and
insert the pod the right way up. The
ap on the pod must be pointing
upwards.
1. Remove the packaging material and
the adhesive strips as well as the
sticker with the serial number on the
drip tray.
2. Remove the water tank and
rinse it out with clear tap water.
3. Replace the water tank again.
4. Fill the water tank with water up to a
maximum level of two nger widths
below the upper edge.
5. Place a container that holds at least
300 ml volume under the outlet .
6. Push the Start-Button / and
wait until the machine is ready to
use.
7. Press the –/+ lling capacity
buttons at the same time
— / / + / .
The tea maker rinses the brewing
container and dispenses water into
the chamber. The machine is fully
rinsed when the Start-Button
/ is continuously illuminated.
8. Empty the contents of the tray of
the drip drawer and
the container into the sink.
7
4
8
1. Remove the water tank and ll
with water up to a maximum level
of two nger widths under the upper
edge of the water tank.
2. Switch on the tea maker.
3. Wait until the Start-Button / is
illuminated constantly.
4. Place a cup under the outlet .
The cup must be able to hold at least
250 ml.
5. Remove the lid foil from the capsule.
6. Open the pod compartment and
insert the capsule the right way up.
The ap on the capsule must be
pointing upwards.
9
18
19
9
Making te a
4
8
2
9
EN
PAGE 32