AWS Snowball User Guide
Transfer Data
At this point, you can change the default network settings through the E Ink display by choosing
Network. To learn more about specifying network settings for the Snowball, see Changing Your IP
Address (p. 49).
Make a note of the IP address shown, because you'll need it to configure the Snowball client.
Important
To prevent corrupting your data, do not disconnect the Snowball or change its network
settings while transferring data.
The Snowball is now connected to your network.
Next: Transfer Data (p. 21)
Transfer Data
The following section discuss the steps involved in transferring data. These steps involve getting your
credentials, downloading and installing the Snowball client tool, and then transferring data from your
data source into the Snowball using the Snowball client.
Note
You can also transfer data programmatically with the Amazon S3 Adapter for Snowball. For
more information, see Transferring Data with the Amazon S3 Adapter for Snowball (p. 65).
Topics
21
To Next Page
Loading...