AWS Snowball User Guide
Doing this gives you access to the touch screen on the E Ink display embedded in the front side of the
Snowball, and the power and network ports in the back.
Remove the cables from the cable catch, and plug the Snowball into power. Each Snowball has been
engineered to support data transfer over RJ45, SFP+ copper, or SFP+ optical 10 gigabit Ethernet. Choose
a networking option, and plug the Snowball into your network. Power on the Snowball by pressing the
power button above the E Ink display.
You’ll hear the Snowball internal fans start up, and the display changes from your shipping label to say
Preparing. Wait a few minutes, and the Ready screen appears. When that happens, the Snowball is ready
to communicate with the Snowball client data transfer tool and accept your incoming traffic.
48
To Next Page
Loading...