1. Service Searching
[ : Press MENU > Setup > Service Searching]
Here you set up the tuners on your receiver and run channel scanning automatically
or manually.
A. Tuner Configuration
[ : MENU > Setup > Service Searching > Tuner Configuration]
If you the First Time Installation process , the Tuner A is already configured.
You can check the information of Tuner A and which satellites are scanned by Tuner A as follows.
B. Automatic Scan of Services
[ : Press MENU > Setup > Service Searching > Automatic Scan]
The easiest way to scan services is to use
Automatic Scan
. In the Automatic Scan menu, there are
two options to choose from as below.
MENU
MENU
MENU
To Next Page
Loading...