genius
ENGLISH
pag.14
Pin 8 Manual error
Pin 9 MIX
7 INSTALLATION AND CONNECTIONS
•
genius
has been conceived according to the present security legislation.
• Before starting Yr
genius
please check that any connection is correct and there are no
wire problems.
• Make sure that the line voltage feeding the system corresponds to that indicated in the
techìnical specifications (chapter 9). ATTENTION:
genius
is set at 220/230VAC, if it is fed
by a different voltage (ex. 110/115 VAC) you need to open the equipment and set the
volatge swithcer on the alimentation circuit, located behind the VDE plug.
• We suggest to use high quality wires, well protected, and balanced connections.
• We suggest to leave an empty space, at least a 19‘’ rack unit, between genius and any
other equipment in order not to alterate the operative temperature.
• The installation must be realised by skilled technicians.
• In case of technical problems or faults please do not open the box and contact AXEL
TECHNOLOGY.
• This manual images could differ a bit from yr
genius
real design.
• Please keep this instruction manual after reading it in detail.
To Next Page
Loading...