Axis 211 Installation Manual

AXIS P13 Series Installation Guide Page 7
ENGLISH
AXIS IP Utility - single camera/small installation
AXIS IP Utility automatically discovers and displays Axis devices on your network. The application
can also be used to manually assign a static IP address.
Note that the computer running AXIS IP Utility must be on the same network segment (physical
subnet) as the network camera.
Automatic discovery
1. Check that the network camera is connected to the network and that power has been applied.
2. Start AXIS IP Utility.
3. When the AXIS P1311/P1343/P1344 appears in the window, double-click to open its home
page.
4. See page 9 for instructions on how to assign the password.
Set the IP address manually (optional)
1. Acquire an unused IP address on the same network segment as your computer.
2. Select the AXIS P1311/P1343/P1344 in the list.
3. Click the button Assign new IP address to selected device and enter the IP address.
4. Click the Assign button and proceed according to instructions.
5. Click the Home Page button to access the camera’s web pages.
6. See page 9 for instructions on how to set the password.

Axis 211 Specifications

General

Camera Type	Network camera
Connectivity	Wired
Image Sensor	1/4" progressive scan CMOS
Resolution	640x480 (VGA)
Operating Conditions	0 °C to 50 °C (32 °F to 122 °F)
Storage Temperature	-20 °C to 60 °C (-4 °F to 140 °F)
Lens	4.0 mm
Viewing Angle	54°
Minimum Illumination	1.5 lux
Video Compression	Motion JPEG
Frame Rate	30 fps
Network Protocols	HTTP, SMTP, FTP, DNS, DDNS, DHCP, ARP, ICMP
Ethernet	10/100