Axis AGN/C Series - Density Determination (Density); Solids Density Determination

44 USER MANUAL
__________________________________________________________________________________________________________________
15.19 Density determination (dEnSity)
The description below describes density determination using HYDRO kit. In case
below-balance weighing, operation sequence does not change.
15.19.1 Solids density determination
This function calculates material
density basing on its weight in air
and in water using the formula
below:
where, m
1
– weigh in air
m
2
– weight in water

L
- density of liquid
If distilled water is used, enter its
exact temperature (accurate to 0,5°C)
– the balance will calculate its
density automatically.
To enter the value use the following
keys:
- digit increase,
- decimal point,
T - next digit,
MENU - end.
When using liquid other than
distilled water or ethanol, choose
OTHER (instead of H2O and
Ethanol) option and enter its density
according to its temperature.
Phase I: measurement in air.
Phase II: measurement in liquid.
To print measurement result and
begin next measurement press
key.
L
mm
m
 *
21
1


0.000g
SoLid
H2O
t C
Press tare
M1
0.0000g
8.9800g
18
dEnsity
dEn on
-
-
MENU
T
T
T
T
T
T
9.7700g
M2