Axis Camera Station - AXIS Camera Station Client; Client Installation and Connection

AXIS Camera Station Client
58 AXIS Camera Station User’s Manual
AXIS Camera Station Client
The AXIS Camera Station Client application is used for remote operations on
client workstations, where you can perform the same tasks as from AXIS
Camera Station (if Administration is enabled).
From a client PC you can acquire and save images, detect motion and save
alarms and images without having to access the server PC where settings and
recordings are stored.
Important!
Note:
Install AXIS Camera Station client software
1. From the client workstation, insert the CD and select Software then AXIS
Camera Station Client
2. Click Open to launch the installation.
AXIS Camera Station uses port 11007 to communicate with the client. On the
server (dedicated PC where AXIS Camera Station is installed), make sure that
port 11007 is open and available for the clients in your network and in your
firewall.
• A maximum of 10 AXIS Camera Station Clients can connect to AXIS
Camera Station simultaneously.
• A PIII 500 MHz PC with 128 MB is the minimum hardware requirement for
AXIS Camera Station Client.
You may be prompted to install .NET Framework 1.1. Simply follow the
installation Wizard’s instructions and click your way through.