Need help?Do you have a question about the Axis ExCam XPT Q6075 and is the answer not in the manual?
General| Camera Type | PTZ |
|---|---|
| Resolution | 3840 x 2160 (4K) |
| Explosion Protection | ATEX, IECEx |
| Ingress Protection | IP66 |
| Operating Temperature | -60°C to 60°C |
| Image Sensor | 1/2.8” progressive scan CMOS |
| Video Compression | H.264, H.265, MJPEG |
| Pan/Tilt | 360° |
| Certifications | ATEX, IECEx |
| Power | 24 V AC |
| Field of View | 65.1° |
| Night Vision | Yes |
| Power Supply | 24 V AC |
| Storage | MicroSD card slot (up to 256GB) |
| Motion Detection | Yes |
| Audio | Two-way audio |
Instructions on locating and assigning IP addresses to Axis devices.
Steps to open the device webpage and log in for the first time.
Guidance on setting a strong password for the administrator account.
Creating privacy masks to obscure specific areas in the video stream.
Configuring network storage for video recordings.
Creating rules to trigger actions based on events like motion detection.
Setting up automatic recording upon motion detection.
Configuring the camera to move to a preset position upon detecting motion.
Managing bandwidth consumption using bitrate control methods.
Adjusting bitrate based on average activity for storage optimization.
Procedures for resetting the device to its original factory settings.
Steps to check the current firmware version for troubleshooting.
Instructions and considerations for upgrading the device firmware.
Common issues and solutions related to firmware upgrades.
Solutions for issues related to setting the device's IP address.
Resolving conflicts when the IP address is already used by another device.
Diagnosing IP conflicts within the same network subnet.
Solutions for when the device is inaccessible via a web browser.
Troubleshooting external access issues for the device.
To Next Page
