EasyManua.ls Logo

Axis P1368-E - Safety Instructions; Transportation; Battery

Axis P1368-E
168 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
AXIS P1368-E Network Camera
Safety instructions
NONO
NO
TICETICE
TICE
The Axis product shall be used in compliance with local laws and regulations.
Store the Axis product in a dry and ventilated environment.
Avoid exposing the Axis product to shocks or heavy pressure.
Do not install the product on unstable poles, brackets, surfaces or walls.
Use only applicable tools when installing the Axis product. Using excessive force with
power tools could cause damage to the product.
Do not use chemicals, caustic agents, or aerosol cleaners.
Use a clean cloth dampened with pure water for cleaning.
Use only accessories that comply with the technical specication of your product. These
can be provided by Axis or a third party. Axis recommends using Axis power source
equipment compatible with your product.
Use only spare parts provided by or recommended by Axis.
Do not attempt to repair the product yourself. Contact Axis support or your Axis reseller
for service matters.
Transportation
NONO
NO
TICETICE
TICE
When transporting the Axis product, use the original packaging or equivalent to prevent
damage to the product.
Battery
The Axis product uses a 3.0 V CR2032 lithium battery as the power supply for its internal real-time
clock (RTC). Under normal conditions this battery will last for a minimum of ve years.
Low battery power affects the operation of the RTC, causing it to reset at every power-up. When
the battery needs replacing, a log message will appear in the product’s server report. For more
information about the server report, see the product´s setup pages or contact Axis support.
The battery should not be replaced unless required, but if the battery does need replacing, contact
Axis support at www.axis.com/support for assistance.
Lithium coin cell 3.0 V batteries contain 1,2-dimethoxyethane; ethylene glycol dimethyl ether
(EGDME), CAS no. 110-71-4.
WARNING
Risk of explosion if the battery is incorrectly replaced.
Replace only with an identical battery or a battery which is recommended by Axis.
30
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com

Table of Contents

Other manuals for Axis P1368-E

Related product manuals