AXIS Q60-S Series
NONO
NO
TICETICE
TICE
• Make sure the connections to the mains supply and conduits have been installed by a
trained professional, according to the manufacturer’s instructions and in compliance
with local regulations.
• The power supply (sold separately) and the media converter switch shall be installed in an
environment protected against dust and water, for example indoors or in an appropriate
cabinet.
• Due to local regulations or the environmental and electrical conditions in which the
product is to be used, a shielded network cable (STP) may be appropriate or required.
All cables connecting the product to the network and that are routed outdoors or in
demanding electrical environments shall be intended for their specic use. Make sure that
the network devices are installed in accordance with the manufacturer’s instructions. For
information about regulatory requirements, see Regulatory Information on page 2.
Important
Axis can only guarantee full functionality with the supplied media converter switch. No
other devices are supported.
1. Make sure the mains supply is switched off.
2. Mount the power supply and the media converter switch on the wall or, if applicable,
attach them to a DIN rail in the cabinet. If drilling is required, make sure to use drill bits,
screws, and plugs that are appropriate for the material.
3. Loosen the screws and remove the cover from the media converter switch.
1
Screw (2x)
2
Cover
3
Media converter switch
24
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
To Next Page
Loading...
Need help?
General
